Kippzonen Brewer MkIII Manual do Utilizador descarregar pdf (Página 15)

MKIII SERVICE MANUAL

D. Type readlog  to display past error history, each line displayed will be a possible clue to the

problem that caused the failure. If motor failures have occurred, the status will tell you which motor

and what the failure is. Usually it is a sensor problem or a wiring problem that prevents the motor

from resetting. If no problems are displayed, then the system can be placed back into cosmac

mode for further testing.

E. Type loadmode  and following the return of the prompt, type cosmacmode . The motors

will reset and within a minute the system will display the status that it is in cosmac mode.

F. Quit the Brewcmd program by typing quit .

11. Run Brewer Software.

Run the Brewer operating program by typing BREWER  to check the correct operation of the

instrument. Select routines that you are familiar with and ensure that all functions and data appear

normal.

12. Replace Main Electronics Board

If no communications return when running Brewcmd then there may be a problem with the Main

Electronics Board.

Replace the Main Electronics board with a spare board, ensuring that all cables are reconnected to

the original connectors. Normally the spare Main Electronics board is preloaded with the same

parameters as those that came with the instrument. Therefore no reprogramming or uploading of

the configuration parameters are needed. If the configuration parameters have changed, then refer

to the procedure to upload new firmware and configuration data to the board, section 8.

The main board has a number of flat cables attached to it. The following lists the connectors for the

flat cables and the electronics they are connected with. “Top” (at the front) stands for pins 1-16.

“Bottom” (at the back) are pins 17-32:

J2 top BA-W77/A Lamp Board

J2 bottom BA-W77/B J1 on hv module

J13 top BA-W76/B iris

J13 bottom BA-W76/A zenith

J14 top BA-W76/B fw #1

J14 bottom BA-W76/B fw#2

J15 top BA-W76/A micrometer #2 (MKIII only)

J15 bottom BA-W76/A micrometer #1

J16 bottom BA-W76/C fw#3 (MK IV only}

J17 top BA-W76/B slitmask (shutter)

J17 bottom BA-W76/A azimuth

J12 top BA-W76/A control switch’s

J7 top Communication

J7 bottom humidity sensor

13. Contact KIPP & ZONEN

If you have followed this procedure and not located the problem contact KIPP & ZONEN for further

assistance.

Webpage: www.kippzonen.com

Email: info.holland@kippzonen.com

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 130 131

Comentários a estes Manuais

Sem comentários

Kippzonen Brewer MkIII Manual do Utilizador Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Instrumentos de medida Kippzonen Brewer MkIII