Kippzonen CFR Calibration Facility Manual do Utilizador descarregar pdf (Página 8)

CFR manual

2.2 Installation

2.2.1 Environmental conditions

To perform accurate calibrations the calibration facility should preferably be installed in a separate room

with temperature controlled and ventilated environment and without spurious light reflections coming from

walls and other objects (ideally a dark-room). Kipp & Zonen reference pyranometers are calibrated at

approximately + 20 ºC, therefore it is strongly recommended to maintain similar environmental conditions.

2.2.2 Mechanical and electrical set-up

The calibration facility must be built up in the following order. The step-by-step procedure is illustrated in

the figures below.

Step 1 Mount the lamp pillar on the table and tightly secure it with the 4 countersunk bolts. The limit cam

should be visible at the front side of the lamp pillar.

figure 1 Calibration table with lamp pillar

Step 2 Slide the lamp mounting bracket over the lamp pillar and place the white clamping disk inside the

bracket.

figure 2 Lamp mounting bracket slid over the lamp pillar

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 28 29

Sem comentários

Kippzonen CFR Calibration Facility Manual do Utilizador Página 8