Kippzonen COMBILOG Data Logger Manual do Utilizador descarregar pdf (Página 125)

<ident> device identification length = 32 byte

<length vendor name> binary (hex 0A) 1 byte

<length controller type> binary (hex 08) 1 byte

<length hw-release> binary (hex 05) 1 byte

<length sw-release> binary (hex 05) 1 byte

<vendor name> ASCII ("Friedrichs") 10 byte

<controller type> ASCII ("COMBILOG") 8 byte

<hw-Revision> ASCII ("xy.yy") 5 byte

<sw-Revision> ASCII ("xy.yy") 5 byte

x … “V“ : universal program

y.yy : version

<Ginfo> device information length = 27 byte

<location> ASCII 20 byte

<serial number> ASCII 6 byte

<number of channels> binary 1 byte

<status> status information length 6 byte

<channel status> binary 4 byte

<module status> binary 2 byte

<channel status> = K32..K25 K24..K17 K16..K9 K8..K1

Byte 1 Byte 2 Byte 3 Byte 4

<module status> = M16..M9 M8..M1

Byte 5 Byte 6

If the bit Kn in the channel status is set it indicates that an error

has occurred in channel n. A channel error is given when the

measuring value is outside of the linearisation, e.g. in case of a

sensor break down or of a short circuit of transmission.

If a bit in the module status is set it indicates that an error has

occurred in the data logger. Valid is:

Hardware Manual COMBILOG 1022

125

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 172 173

Sem comentários

Kippzonen COMBILOG Data Logger Manual do Utilizador Página 125