Kippzonen Brewer MkIII Manual do Utilizador descarregar pdf (Página 26)

MKIII OPERATOR’S MANUAL

3 BREWER SYSTEM SETUP

Prior to accepting a shipment from the carrier, the containers should be inspected for

damage. If any dents or major scratches, cuts, etc. are evident, a damage claim should be

filed with the carrier. Only after incoming inspection and operational tests of the Brewer are

successfully completed, should the shipment be accepted.

These instruction lead an installer through the Setup of a Brewer Spectrometer.

Since Brewers are usually operated at some distance from the Computer Equipment, (probably out

of doors, and out of site of the Computer room), the setup will be done in two stages. The Brewer

will first be set up and tested in close proximity to the Computer, and then it will be installed at its

final location.

Before starting, ensure that correct AC voltage is availabe as per the diagram in Figure 3.1 and

Table 3.1.

Figure 3.1: AC Power Voltages

Table 3.1 AC Power Connector Voltages

measured voltages between

230VAC installations

120VAC installations

ground & neutral

0 VAC

ground & hot

240 VAC

120 VAC

neutral & hot

240 VAC

120 VAC

REFER TO FIGURES 3.2 and 3.3 FOR THE FOLLOWING SETUP

The complete Brewer Spectrometer system consists of the following:

• a Spectrophotometer

• an Azimuth Tracker

• a Tripod Stand

• a Control and Data Logging Computer (optionally from KIPP & ZONEN)

• a set of Interconnect Cables

• a set of Basic Spare Parts

• a set of Optional Spare Parts

• other Optional parts

3. BREWER SYSTEM SETUP

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 135 136

Sem comentários

Kippzonen Brewer MkIII Manual do Utilizador Página 26